Hot Water Repairs Wantirna
Cold shower this morning, a relief valve that will not stop dripping or water pooling under the cylinder? We repair electric, solar and heat pump hot water systems across Wantirna. Ring 03 9069 5874.
- Licensed and insured
- Local to Wantirna 3152
- Quote agreed first
- After-hours call-outs

Hot water problems we fix
Hot water is one of those things nobody thinks about until it stops. In Wantirna we see the same handful of faults again and again, mostly on electric storage cylinders, which are still the most common system in the suburb's 1970s and 1980s homes, along with a growing number of heat pump and solar units.
No hot water at all
When the taps run completely cold, the cause is usually electrical or a failed heating component. On an electric storage unit, the usual suspects are:
- A tripped circuit or blown fuse at the switchboard. Many Wantirna homes have the hot water on a separate off-peak circuit, sometimes with its own timer or a separate meter.
- A failed heating element. Elements burn out with age, especially in hard or sediment-heavy water, and can short to earth, which trips the safety switch.
- A failed thermostat or over-temperature cut-out. The thermostat controls the element; the cut-out shuts it off if the water overheats. Either can fail and stop heating.
- Wiring faults at the element terminals, often from heat damage or corrosion.
On a heat pump, no hot water can come from a fault in the compressor, fan, controller or sensors, or from an electric boost element that has failed in cold weather. On solar systems, it can be a pump, a controller or a boost element that has stopped working.
Lukewarm or not hot enough
If the water is warm but never properly hot, or runs out much faster than it used to, possible causes include:
- One of two elements has failed. Some larger cylinders have two elements. If one goes, you get some hot water, but not much.
- Thermostat set too low or drifting with age.
- Sediment build-up in the base of the cylinder, insulating the water from the element and reducing the tank's usable volume.
- A faulty tempering valve mixing in too much cold water at the bathroom taps.
- A crossed connection in the plumbing, where cold water is leaking into the hot line through a faulty mixer tap.
- The off-peak heating window being too short for the household's use.
Why is my hot water not coming out hot enough?
Most often it is one of three things: the system is not heating fully (a failed element, low thermostat setting or sediment), the tempering valve is mixing too much cold water in, or cold water is crossing into the hot line through a worn mixer tap. If it is only one tap, look at the tap or tempering valve; if it is every tap, look at the heater. We test the water temperature at the cylinder and at the fixtures to tell which.
Leaking relief valve
Every storage hot water system has a temperature and pressure relief valve on top or near the top of the tank. It is a safety device that lets water out if the pressure or temperature inside gets too high. A little discharge while the water is heating is normal. A constant stream, or a valve that drips all day and night, is not.
A worn relief valve is the most common reason for steady dripping. Valves should be replaced roughly every five years. But a relief valve can also be discharging because the mains water pressure is too high, or because the expansion control valve on the cold inlet has failed. If we replace the valve without checking the cause, the new one will start dripping too. We check pressure first. See water pressure problems.
Leaking from the base of the cylinder
Water pooling under a storage cylinder, or rust stains running down the outer casing, usually means the inner tank has corroded through. Once the tank itself is leaking, it cannot be repaired and the unit needs replacing. Sometimes the leak is actually from a fitting or valve at the base and can be fixed, so it is worth having it checked properly before assuming the worst. Turn off the power to the unit and the cold water supply valve at the tank, and give us a call. Our hot water replacement page explains the options if it does need a new unit.
Noisy hot water system
Rumbling, popping or crackling from a storage cylinder usually points to sediment in the base, which boils in pockets around the element. Hammering or banging in the pipes can be caused by high pressure or a faulty valve. High-pitched whistling might be a valve that is partly closed. On heat pumps, some fan and compressor noise is normal, but grinding or rattling is a sign of a fault.
Discoloured or smelly hot water
Rusty brown hot water can mean the inside of the tank is corroding, often because the sacrificial anode has been used up. A rotten egg smell is usually caused by bacteria reacting with the anode in the tank. Replacing the anode, flushing the tank or changing the anode type often fixes it.
Who to contact if I have no hot water?
Start with your switchboard. If the hot water circuit or the safety switch has tripped, try resetting it once. If it trips again straight away, leave it off; there is likely an electrical fault in the element or wiring. If your home is on a separate off-peak tariff, also check that the timer or off-peak meter is working, or ask your electricity retailer whether there is a supply problem. If the power is fine and there is still no hot water, call a licensed plumber. Our guide How old is your hot water cylinder? will help you tell whether it is worth repairing.
How we repair hot water systems
When we arrive, we start by checking the system as a whole rather than replacing the first part that looks tired. On an electric storage unit, we:
- Isolate the power safely and test the element and thermostat with a multimeter.
- Check the relief valve, the expansion control valve and the cold inlet valves.
- Test the mains pressure, to make sure valves are not being overloaded.
- Look at the age, condition and model of the cylinder, including rust, leaks and anode condition.
- Check the tempering valve, which limits the temperature delivered to the bathrooms.
We then explain what has failed, whether it is worth repairing given the unit's age, and what the repair involves. We carry the common elements, thermostats, relief valves and expansion control valves for the systems we see most often in Wantirna, so most repairs are done on the first visit.
Is it worth repairing?
Usually, a repair makes sense when the tank itself is sound and the unit is under about ten years old. A new element, thermostat or relief valve can give a good unit years more service. If the cylinder is older than twelve to fifteen years, has signs of rust or seepage, or has needed several repairs, replacing it is often the better choice. Repeated repairs to an old tank are money you will not get back when the tank eventually fails. We tell you honestly which way we would go if it were our own home.
Electric storage systems
Electric storage cylinders heat water with one or two elements and store it in an insulated tank, typically somewhere between 125 and 400 litres for a household. In Wantirna they are usually in the laundry, a cupboard, the garage or outside against the wall. Many run on off-peak power, heating overnight. They are reliable but are expensive to run compared with a heat pump, and many original units here are now at or past the end of their working life.
Heat pump systems
A heat pump works like a reverse-cycle air conditioner, extracting heat from the surrounding air and transferring it to the water. It uses a fraction of the electricity of a standard electric cylinder. We repair heat pump systems, including boost elements, fans, sensors, controllers, valves and leaks. Where a fault is in the refrigeration circuit or under the manufacturer's warranty, we help organise the manufacturer's service. If you are thinking about switching, see heat pump hot water and our guide Heat pump or electric for a Wantirna home?.
Solar hot water
Wantirna has a fair number of roof-mounted and split solar systems installed in the 2000s and 2010s. We repair circulating pumps, controllers, boost elements, valves and leaking pipe runs, and we check the frost protection valves that stop roof panels from freezing on cold nights.
Hot water temperature and safety
In Victoria, stored hot water must be kept at 60°C or above to prevent the growth of Legionella bacteria. But water at that temperature can scald, especially children and older people. So for new installations, a tempering valve is fitted to limit the temperature to the bathrooms to no more than 50°C. Many older Wantirna homes have no tempering valve at all, or one that has not been serviced in years. We check them and can fit or replace them. Our guide Tempering valves and scald safety explains more.
Hot water maintenance
A little care extends the life of a storage cylinder:
- Ease the relief valve lever gently every six months, letting a little water run, then let it snap back. This stops it seizing. If it does not reseal, call us.
- Check for leaks and rust around the base and fittings.
- Have the anode checked every few years, more often in areas with harder water. Replacing a worn anode can add years to the tank.
- Replace the relief valve around every five years.
- Keep the area clear around heat pumps, so air can circulate.
Common hot water setups in Wantirna homes
Because so much of Wantirna was built within a decade or so, many homes share similar hot water arrangements, and each has its own quirks.
The laundry cylinder. In a lot of single-storey brick veneers the original electric cylinder sits in the laundry or a cupboard beside it, with the relief valve drain running out through the wall. Space is tight, so when a replacement is needed the new unit has to fit the same footprint, and the drain line and tray must still work. A failing unit here can also do real damage to timber floors and skirting, so leaks need attention quickly.
The outdoor cylinder. Others have the cylinder outside on a concrete pad against the side or back wall, usually a mains-pressure unit. These suffer more from weather, with corroded casings and sun-damaged insulation on pipework. They are also a natural spot for a heat pump when the time comes.
Units and townhouses. In the units and townhouse developments around Mountain Highway, Boronia Road and near Knox, hot water units are often small and squeezed into cupboards, balconies or garages. Access and drainage can be tricky, and body corporate rules may affect where a replacement can go. We work around those constraints.
Solar retrofits. Some homes added roof-mounted solar collectors to an existing cylinder in the 2000s. Those systems now have ageing pumps, controllers and valves, and the plumbing between roof and tank needs regular checks for leaks.
Knowing these patterns means we can usually tell on the phone what kind of system you have and which parts to bring.
What to tell us when you call
To help us arrive with the right parts, it helps to have:
- The brand and model from the label on the side of the unit, and the capacity in litres.
- Roughly how old it is, if you know, or the manufacture date on the label.
- What is happening: no hot water, not hot enough, leaking, noisy, discoloured.
- Whether the switchboard has tripped and whether it trips again when reset.
- Where the unit is and whether access is easy.
A photo of the label and the area around the unit, sent after you call, is even better.
Hot water repairs in nearby suburbs
We repair hot water systems in Wantirna 3152 and across Wantirna South, Bayswater, Boronia, Vermont South, Vermont, Knoxfield, Scoresby and Heathmont.
What comes with hot water repairs
- Equipment
- Drain camera and locator, high-pressure jetter, electric drain machine, acoustic leak detector, thermal camera, pressure gauges
- Licences
- Victorian plumbing licences for water supply, sanitary, drainage and roofing
- Pricing
- The cause explained and the price agreed before work; written quotes for bigger jobs
- Materials
- WaterMark-certified fittings and products that meet Australian Standards
- Paperwork
- Compliance certificates for regulated work, plus photos for your records or insurer
- Clean-up
- Old parts taken away, the work area cleaned, and the repair tested with you
Hot Water Repairs in Wantirna: your questions
Who to contact if I have no hot water?
Check the switchboard first and reset the hot water circuit or safety switch once. If it trips again or there is still no hot water with the power on, call a licensed plumber. If you are on an off-peak tariff and the whole off-peak supply is out, your electricity retailer may need to be contacted.
Why is my hot water not coming out hot enough?
Usually a failed element, a thermostat set too low, sediment in the tank, a faulty tempering valve or cold water crossing into the hot line through a worn mixer tap. We test the temperature at the tank and at the taps to tell which.
Why is the relief valve on my hot water dripping?
A small discharge while heating is normal. Constant dripping usually means the valve is worn, the mains pressure is too high or the expansion control valve has failed. We check the pressure before replacing anything.
Is it worth repairing an old hot water system?
If the tank is sound and under about ten years old, a repair usually makes sense. If it is older than twelve to fifteen years, rusty, leaking from the tank or has needed several repairs, replacement is usually the better spend.
Can you repair heat pump and solar hot water systems?
Yes. We repair boost elements, pumps, fans, sensors, controllers, valves and leaks. For refrigeration faults or warranty work, we help organise the manufacturer's service.
How long does a hot water repair take?
Most element, thermostat and valve repairs are done in a single visit, often within an hour or two of arriving, because we carry the common parts for the systems found in Wantirna homes.
Before you call, read this
Tell us what needs fixing
Tell us about the job and a licensed Wantirna plumber will ring you back. If water is flooding or a sewer is overflowing, do not wait for a reply: call 03 9069 5874 now.
Every job is priced on what we find on the day, so there is no price list here. You will always know the cost before we start.
From your call to a finished repair
Four steps, the same on every job, whether it is a dripping tap or a sewer overflowing at midnight.
- 01You call or send the form
Say what is going on and roughly where on the property. If you can, snap a photo of the leak, the tap or the label on the hot water unit so the right parts come in the ute.
- 02We find the cause
On site we trace the fault, show you what we found and explain the options. You get the price before any fitting is undone.
- 03The repair, tested
Work is done to the Plumbing Regulations and Australian Standards, then run and tested while you watch. Regulated jobs come with a compliance certificate.
- 04Tidy finish and a follow-up
Old parts go in the ute, the work area is wiped down, and we check in a few days later to make sure everything is still dry and working.
Other plumbing jobs we take on in Wantirna
Where we work around Wantirna
Home base is Wantirna, between the Dandenong Creek parklands and Knox City. From here it is a short run to Wantirna South over High Street Road and Scoresby beyond it, Bayswater and Boronia to the east, Vermont South and Vermont over the Whitehorse line, Knoxfield down Stud Road and Heathmont across the creek to the north. Not on the list? Ring 03 9069 5874 and ask.
Need a plumber in Wantirna?
A licensed local plumber picks up, and the cost is settled before any tools come out.