Water Pressure Problems Wantirna
Shower barely more than a trickle, pipes banging when a tap closes or a relief valve that drips all day? We test the water pressure and fix the cause across Wantirna. Ring 03 9069 5874.
- Licensed and insured
- Local to Wantirna 3152
- Quote agreed first
- After-hours call-outs

Low pressure or high pressure?
Water pressure problems go both ways, and both cause trouble.
Low pressure shows up as a weak shower, taps that take forever to fill a bucket, a hot water system that cannot keep up, or pressure dropping sharply when two taps run at once.
High pressure is less obvious, but it strains every pipe, valve and appliance in the house. Signs include banging pipes when taps close, hot water relief valves discharging constantly, taps and toilets wearing out quickly, and splashing at basins.
The first step is always to measure. We screw a pressure gauge onto an outside tap near the meter and take readings, both static and while water is flowing.
Causes of low water pressure
- Corroded galvanised pipes. Older galvanised steel pipes rust from the inside, narrowing the bore until flow is badly restricted.
- A failing pressure limiting valve. If your home has one, it can fail and restrict flow.
- A partly closed valve. The meter tap or an isolation valve might not be fully open, sometimes after earlier repairs.
- A hidden leak. Water escaping through a broken pipe reduces pressure at the taps. See leak detection.
- Blocked aerators or shower heads, if only one fixture is affected.
- Undersized pipework that cannot supply several fixtures at once, especially after extensions.
- Hot water system issues, if only the hot taps are weak. A blocked valve or tempering valve can reduce hot water flow.
- Supply issues in the street, though this is less common.
Causes of high water pressure
Mains pressure varies across Melbourne and can be quite high in parts of the eastern suburbs, depending on where you are in relation to reservoirs and pumping stations. Wantirna's lower-lying streets can see higher pressure than the ridges. Without a pressure limiting valve, that full mains pressure reaches every fitting in the house.
Pressure limiting valves
A pressure limiting valve, usually fitted near the water meter, reduces incoming mains pressure to a safe level for household plumbing. In Victoria, the Plumbing Regulations and Australian Standards set maximum pressure limits at outlets inside a home, and a pressure limiting valve is required where mains pressure exceeds them. Many older Wantirna homes were built without one.
Pressure limiting valves wear out like any valve. A failed valve can either let full mains pressure through or restrict the flow too much. We test the pressure before and after the valve to check it is working and replace it if needed.
Water hammer
Water hammer is the banging or thudding noise when a tap, toilet or washing machine valve closes quickly. The moving water stops suddenly and the pressure wave travels back through the pipes. High pressure makes it worse, and loose pipes under the floor or in walls amplify the noise. Over time, water hammer can damage fittings and cause leaks.
Fixes include reducing pressure with a pressure limiting valve, securing loose pipes, fitting water hammer arrestors near quick-closing valves and replacing faulty valves.
How we fix pressure problems
- Measure static and flowing pressure at the meter and at affected fixtures.
- Check valves at the meter, the pressure limiting valve, isolation valves and the hot water system.
- Look for leaks if pressure is low and the meter is moving.
- Assess pipework, including any galvanised sections that may be restricting flow.
- Recommend the fix and give you the price before we start.
Common repairs include fitting or replacing a pressure limiting valve, replacing corroded galvanised pipes with copper or plastic, clearing blocked aerators and shower heads, and repairing leaks.
Water pressure and hot water
High pressure is a common reason for hot water relief valves to discharge constantly. If your relief valve is always dripping, the pressure should be checked before the valve is replaced. See hot water repairs.
Water pressure problems near Wantirna
We test and fix water pressure in Wantirna 3152 and in Wantirna South, Vermont South, Vermont, Heathmont, Bayswater and Knoxfield.
What comes with water pressure problems
- Equipment
- Drain camera and locator, high-pressure jetter, electric drain machine, acoustic leak detector, thermal camera, pressure gauges
- Licences
- Victorian plumbing licences for water supply, sanitary, drainage and roofing
- Pricing
- The cause explained and the price agreed before work; written quotes for bigger jobs
- Materials
- WaterMark-certified fittings and products that meet Australian Standards
- Paperwork
- Compliance certificates for regulated work, plus photos for your records or insurer
- Clean-up
- Old parts taken away, the work area cleaned, and the repair tested with you
Water Pressure Problems in Wantirna: your questions
What makes household water pressure drop?
Common causes are corroded galvanised pipes, a failed pressure limiting valve, a partly closed valve, a hidden leak or a blocked shower head or aerator. Measuring the pressure narrows it down.
What causes a loud thud in the pipes when a tap shuts?
That is water hammer, caused by water stopping suddenly. High pressure and loose pipes make it worse. A pressure limiting valve, pipe clips or a water hammer arrestor usually fixes it.
Do I need a pressure limiting valve?
If mains pressure at your property is above the limit for household plumbing, yes. Many older Wantirna homes do not have one. We can test and advise.
Can high water pressure damage my plumbing?
Yes. It strains pipes, valves, taps, toilets and appliances, and can cause leaks and constant hot water relief valve discharge.
Why is only my hot water pressure low?
Often a valve at the hot water system, a faulty tempering valve or sediment restricting flow. We check the system and its valves.
How do you test water pressure?
We fit a pressure gauge to a tap near the meter and measure static pressure and pressure while water is flowing.
Before you call, read this
Tell us what needs fixing
Tell us about the job and a licensed Wantirna plumber will ring you back. If water is flooding or a sewer is overflowing, do not wait for a reply: call 03 9069 5874 now.
Every job is priced on what we find on the day, so there is no price list here. You will always know the cost before we start.
From your call to a finished repair
Four steps, the same on every job, whether it is a dripping tap or a sewer overflowing at midnight.
- 01You call or send the form
Say what is going on and roughly where on the property. If you can, snap a photo of the leak, the tap or the label on the hot water unit so the right parts come in the ute.
- 02We find the cause
On site we trace the fault, show you what we found and explain the options. You get the price before any fitting is undone.
- 03The repair, tested
Work is done to the Plumbing Regulations and Australian Standards, then run and tested while you watch. Regulated jobs come with a compliance certificate.
- 04Tidy finish and a follow-up
Old parts go in the ute, the work area is wiped down, and we check in a few days later to make sure everything is still dry and working.
Other plumbing jobs we take on in Wantirna
Where we work around Wantirna
Home base is Wantirna, between the Dandenong Creek parklands and Knox City. From here it is a short run to Wantirna South over High Street Road and Scoresby beyond it, Bayswater and Boronia to the east, Vermont South and Vermont over the Whitehorse line, Knoxfield down Stud Road and Heathmont across the creek to the north. Not on the list? Ring 03 9069 5874 and ask.
Need a plumber in Wantirna?
A licensed local plumber picks up, and the cost is settled before any tools come out.